Just a test for my new CNC machine. I got the file from here: Scantheworld and turned it into a relief using ZBrush and Photoshop. The wood I used is cherry and the sice of the carving is roughly 60x50mm.
I decided to sand down the top, drawer front, and low shelf edges, but leave the spindles alone. I tried to match the stain but the one I bought (and tried on a hidden area) came out too red, so I skipped staining. Luckily several coats of poly ended up close enough....
It has seen some water damage and the varnish is flaking off (especially on the top). But I don't necessarily have the time/energy for a full strip/sand/refinish, especially as this may get dinged up; I'm just looking for a reasonably pleasing look....
I'm guessing this is the result of layers of slathering a fresh layer of finish on these tables. To be honest, I kind of like the look. Any idea what type of finish this might be?...
My family had one from decades ago that's falling apart, so I made a replacement. I went with toothpicks as little dowels to help join the crossbars to their supports, since the flat glue joint didn't hold for all of them....
It's actually just friction fit together in this picture; as I type it's in the clamps as the glue dries. Tomorrow some final touch up sanding and the first of four coats of spar varnish, then a few decades on my front porch under a couple potted plants....
I was checking to see how a 3/4" dog hole would look in a vise jaw made from two 3/4" pieces of plywood. Just clamped for the test, but would be glue for the real thing. Interesting to see the hole opened up. And luckily no splitting, but do you think it would work as an actual vise jaw? This is for a Veritas quick release front...
I had an old can of poly in the basement, and decided to give it a try. Thin crust on top, poured kind of like egg whites. But after mixing with mineral spirits it seemed smooth, and the result on my new plywood workbench top is smooth and fully cured as far as I can tell....